Domo DO223S Manual De Instrucciones página 21

· Empty the dust container.
· Remove the filters from the dust container and clean them under running water. Do not use hot water
or detergent.
· Let the filters dry and replace them in the dust container. Make sure the filters are completely dry
before using the appliance again.
UV LIGHT
· To guarantee an optimal functioning of the UV light, the lamp needs to be cleaned regularly. Make
sure you will not leave any finger prints on the lamp after cleaning, as this can influence the operation
of the lamp.
· Remove the screws and the cover of the UV light.
· Clean the lamp using a soft, dry cloth.
· Replace the cover and the screws after cleaning.
· In case of a defect of the lamp, contact the after sales service. The lamp needs to be replaced by the
repair service.
ROTATING BRUSH
· To remove the cover of the rotating brush, loosen the screws and press the tabs of the cover.
· Remove dirt and hair from the brush. If necessary, use scissors.
· Replace the cover and the screws after cleaning.
www.domo-elektro.be
Remove the Screws firts
6
Push the releas
buttons
DO223S
21