Adjusting The Screen Display (When Using A Digital Signal) - Sharp LL-T18A1 Manual De Funcionamiento

Adjusting the screen display
Adjustments can be made using On Screen
Display (OSD) Menu provided.
On Screen Display for adjustment
If you are using Windows, open the Adjustment
Pattern on the accompanying Utility Disk. (p.14).
If your system is not Windows, you can not use the
Adjustment Pattern. Therefore display an image
that makes the entire screen light and adjust it
through checking visually its actual tone.
This chapter provides the procedure how to adjust
the screen by using Adjustment Pattern (for
Windows)
How to adjust
1.Press the MENU button.
The COLOR CONTROL Menu will be displayed.
C N T O
C L OR O O R
[ C L OR O M D E O s G B
WH I T E B A L A N E C
C O O L S T D
R-CONTRAST
G-CONTRAST
B-CONTRAST
4
1 2 8 0 x 1 0 2
V : 7 5 H z
At this point relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (COLOR CONTROL → MODE
SELECT → OSD Menu disappears)
Note:
- The OSD Menu automatically disappears several
seconds after the last command.
< D I G I T A L >
L
R ST D V V I D I ]
U E S R
WA R M
H : 8 0 k H z
(When using a digital signal)
COLOR CONTROL Menu
C L OR O C N T O
O
[ C L OR O M D E O
WH I T E B A L A N E
C O O L S T D
R-CONTRAST
G-CONTRAST
B-CONTRAST
1 2 8 0 x 1 0 2 4
V : 7 5 H z
Notes:
- To choose a menu option:
- To go to the next menu: MENU button
COLOR MODE
Color tone can be set as below. (
sRGB: sRGB is international standard of color
representation specified by IEC
(International Electrotechnical Commis-
sion). Color conversion is made in
taking account of liquid crystal's
characteristics and represents color
tone close to it original image.
STD: Displays image with the color tone
results from original scheme of liquid
crystal panel.
VIVID: Displays an image with dynamic and
VIVID primary colors.
- If [sRGB] or [VIVID] has been selected, items
subsequent to [WHITE BALANCE] cannot be set.
WHITE BALANCE
- Use the buttons to select [COOL], [·], [STD],
[·], [WARM] or [USER].
- Selecting [USER] will display the setting values
for [R-CONTRAST], [G-CONTRAST] and [B-
CONTRAST], in order to make fine adjustments.
- Use the button to select [R-CONTRAST], [G-
CONTRAST] and [B-CONTRAST].
COOL ... Color tone bluer than standard
• .........Color tone slightly bluer than standard
STD ...... Color tone standard setting
• .........Color tone slightly redder than standard
WARM .. Color tone redder than standard
USER
R-CONTRAST .....
G-CONTRAST .....
B-CONTRAST .....
18
>
L < D I G I T A L
R
s G B R ST D V V I D I
]
C
WA U E S R
R M
H : 8 0 k H z
button
buttons)
button for blue-green
button for red
button for purple
button for green
button for yellow
button for blue