Setup And Operating Procedures; Battery Loading - AEG BMG 5610 Instrucciones De Servicio

English
122
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the device to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
16. This blood pressure monitor is verified by auscultatory method. It is recommended that you check
annex B of ANSI/AAMI SP-10:2002+A1:2003+A2:2006 for details of verification method if you need.

SETUP AND OPERATING PROCEDURES

1.

BATTERY LOADING

a. Open battery cover at the back of the monitor.
b. Load four batteries of the type "AAA" Please pay attention to polarity.
c. Close the battery cover.
When the LCD shows the battery symbol
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid relevant damage of
battery leakage.
Do not let battery fluid get into your eyes. If it should get in your eyes, immediately rinse with
plenty of clean water and contact a physician.
, replace all batteries with new ones.