Smeg KT110ABL Manual De Instrucciones página 12

WARNING!
Read the instructions carefully before installing and/or using the hood.
•
Before connecting, make sure that the mains voltage corresponds to the voltage on
•
the rating plate inside the hood. (see fig. 7)
Once you remove the appliance from its packaging make sure it is intact. If the
•
product is damaged, do not use it and contact the Smeg assistance network.
It is recommended that a qualified technician performs installation and adjustment
•
.
operations
The minimum distance between the cooker and the lower part of the hood must be
•
750mm for gas cookers and 650 mm for electric cookers.
Before carrying out any kind of maintenance or cleaning, disconnect the hood from
•
the mains supply.
Inspect and clean the filters thoroughly and in accordance with the intervals
•
suggested by the manufacturer.
Do not cook or fry in a way that could result in flames being sucked into the hood and
•
causing a fire.
The hood surface can be cleaned with a damp cloth and a non-bleach liquid
•
detergent.
Make sure the room is properly ventilated when using the hood and other gas
•
appliances at the same time.
Comply with the regulations on air discharge when operating the hood.
•
The extracted air must not be routed into a duct used to discharge fumes of gas-
•
operated appliances.
This appliance must not be used by children without an adult supervision or
•
by disabled people without assistance.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE IF THE ABOVE
•
INSTRUCTIONS ARE NOT FOLLOWED.
OPERATION
This appliance has been designed to work as a DUCTING hood (evacuation of the
air) or RECYCLING hood (recycling of the filtered air).
DUCTED MODE: In order to use the hood in the ducted mode, connect the motor
•
intake, by means of a suitable ducting hose not less than 120mm diameter, directly to
the external fumes outlet.
Note: Remove any carbon filters.
RECIRCULATION MODE: If it is not possible to discharge fumes outside, the hood
•
can be used to filter and recycle the air. This way, air and fumes are filtered by the
anti-odour carbon filters and recirculated through the aerating grids on the sides of
chimney.
EN 01