Restoring Factory Settings; Specifications - Esoteric N-05 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting (continued)

Restoring factory settings

Settings are retained even if the power plug is disconnected.
Follow these procedures to restore all settings to their factory
defaults and clear the unit's memory.
1
Turn the unit off.
If the unit is on, press the POWER button to turn it off and wait
for more than 30 seconds.
2
Press the POWER button while holding down the
MENU button.
When "Setup CLR" (clear settings) appears on the display, release
the MENU button.
Note about condensation
If this unit is brought from a cold outdoor environment into a
warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur on
operating parts or lenses, resulting in improper operation. If this
occurs, leave the unit on and wait 1–2 hours. This should enable
normal playback.
20

Specifications

Digital audio inputs
RCA connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 pairs (L/R)
Input level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 Vp-p
Input impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 Ω
Input signal format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32–192 kHz
Optical digital connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Input level . . . . . . . . . . . . . . . . . . . . . . . . .−24.0 dBm to −14.5 dBm (peak)
Input signal format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32–192 kHz
USB port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 (Type B)
Input signal format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.1–384 kHz
ETHERNET port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000BASE-T
Input signal format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.1–384 kHz
Supported file formats
DSD lossless . . . . . . . . . . . . . . . . . . . . . . . . . . . . DSF, DSDIFF (DFF), DoP
PCM lossless . . . . . . . . . . . FLAC, Apple Lossless (ALAC), WAV, AIFF
Compressed audio . . . . . . . . . . . . . . . . . . MP3, AAC (m4a container)
USB DRIVE port . . . . . . . . . . . . . . . .FAT32; USB 2.0 or faster recommended
Digital audio output
RCA connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Output level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.5 Vp-p (into 75Ω load)
Output impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 Ω
Output signal format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.1–192 kHz
16-bit to 24-bit
Linear PCM (IEC 60958 format)
DSD (DoP format)
16-bit to 24-bit
Linear PCM (IEC 60958 format)
DSD (DoP format)
16-bit to 32-bit
Linear PCM
2.8/5.6/11.2MHz DSD
16-bit to 32-bit
Linear PCM
2.8/5.6MHz DSD
16-bit to 24-bit
Linear PCM (IEC 60958 format)
DSD (DoP format)

Publicidad

Tabla de contenido
loading

Tabla de contenido