REV 468344 Instrucciones De Montaje página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
Troubleshooting:
Control-LED for transmit-
ter #6 doesn't light.
The sending control-LED
#6 lights, but there's no
chime-signal.
The chime doesn't work
reliable, although the
function was acceptable
before.
Chime signal is activated
undesirably.
Range too low.
Type 468344:
Hereby, REV Ritter GmbH declares that the radio equipment type
468344 is in compliance with Directive 2014/53/EU. The full text of
the EU declaration of conformity is available at the following internet
address: www.rev.biz
WEEE-reference of disposal:
In accordance with European defaults used electrical and electronics
devices may no more be given to the unsorted waste. The symbol of
the waste bin on wheels refers to the necessity of separate collection.
Please help with environmental protection and see to it that this device
is given to the for this purpose designated systems of waste sorting if
you do not use it any longer. DIRECTIVE 2012/19/EU of the
EUROPEAN PARLIAMENT AND OF the COUNCIL of 4 July 2012 on waste
electrical and electronic equipment (WEEE).
- Is the battery inserted right?
- Is the battery in the push-button ok?
- Is the On/Off-button on the chime in the mode „ON"?
- Are the batteries inside the chime ok?
- Are the batteries inserted in the right direction?
- Is the range of the radio-signal sufficient?
Approach the devices and check the function again.
- Are the batteries of the push-button and the chime still
ok? (If necessary, replace them by new ones)
- Are there other radio devices in use? (If neccessary,
change channel settings on the chime and the
push-button: see „Change of code in the case of
interferences").
- Choose position of assembly, so that the distance
between push-button and chime is as low as possible.
- Change position of assembly a little (+/- 15 cm) and
check again.
- If it is possible, don't place the chime in corners (distance
of every edge at least 1m).
- Choose position of assembly, so that there are as few
walls as possible between the push-button and the
chime unit.

Publicidad

Tabla de contenido
loading

Productos relacionados para REV 468344

Tabla de contenido