Mitsubishi Electric PAC-SF29LB Manual De Instalación página 11

Warning:
• Be sure to use the specified wires for connection so that no external force is imparted to the terminal connections. If the wires are not
securely connected, a fire can occur.
• Be sure to use the appropriate type of overcurrent protection switch. Note that generated overcurrent may include some amount of direct
current.
Caution:
• Some installation sites may require a ground-fault interrupter. If a ground-fault interrupter is not installed, an electric shock can occur.
• Use only a circuit breaker and fuse of the specified capacity. Using a fuse and copper wire with excessive capacity can cause a malfunc-
tion or a fire.
When connected to a CITY MULTI indoor unit in a system
M-NET system remote controllers cannot be used to operate the indoor unit that is connected to the R-Converter.
(1) Example of setting an address automatically
A
Adr.000
B B
Adr.000 Adr.000
C C
D D
A Outdoor unit
B R-Converter unit
C Indoor unit
D Remote controller
E CITY MULTI indoor unit
F Unit remote controller (MA)
G M-NET transmission cable
(3) Group settings including R-Converter units are not possible.
A
Adr.051
E E
Adr.001 Adr.002
H
Adr.101
A Outdoor unit
B R-Converter unit
C Indoor unit
D Remote controller
E CITY MULTI indoor unit
G M-NET transmission cable
H Network remote controller (NR)
G
E E
Adr.000 Adr.000
F F
G
B B
Adr.003 Adr.004
C C
D D
(2) Example of a group setting not including R-Converter units
A
Adr.051
B B
Adr.001 Adr.002
C C
D D
Adr.103
A Outdoor unit
B R-Converter unit
C Indoor unit
D Remote controller
E CITY MULTI indoor unit
G M-NET transmission cable
H Network remote controller (NR)
(4) Connecting to a system remote controller is not possible.
A
Adr.051
B
Adr.001 Adr.002
C
I D
A Outdoor unit
B R-Converter unit
C Indoor unit
D Remote controller
E CITY MULTI indoor unit
G M-NET transmission cable
H Network remote controller (NR)
I System remote controller (SC)
G
E E
Adr.003 Adr.004
H H
A
G
Adr.053
B E E
Adr.003 Adr.004
C
H
D
Adr.103
11