Getting Started - Lotus 14005R4 Manual De Uso

4 Easy steps:
Step 1: Installing the Carbon-Block Filter
First, remove the carbon-block filter from the plastic bag and remove the red cap and
plug found at either end.
Next, lift off the filter housing cap. It is a fitted cap and should come off with a gentle
pull. (FIGURE 1)
FIGURE 1
Insert filter and turn clockwise to lockin place. The arrow and lock symbol on the filter
should line up with the arrow on the filter housing. (FIGURE 2)
Step 2: Fill the Processing Carafe
If the Processing Carafe is locked into place, simply remove it from the unit by holding
the handle and rotating it counterclockwise. You will feel the water Processing Carafe
unlock from its base. Ensure that the pre-filter screen is in place on the Processing Carafe.
Next, fill your water Processing Carafe with cool water to the fill line. (FIGURE 3)
FIGURE 2
Place the Processing Carafe back onto the base and lockin place. Make certain the
lock symbol on the processing carafe lines up with the lock symbol on the main
unit.(FIGURE 4)
Step 3: Programming for municipal water, lake or well
water
FIGURE 3
1.
Municipal water mode for municipal tap water
2.
Lake or well water mode for visually clear lake or well water*
The system can operate in two modes and treat various types of water.*
*Tested and verified by independent laboratory testing for the bacterial and protozoa
claims on the Performance Data List on page 16. NSF Certification for a microbiological
claim is for Cyst Reduction only.
FIGURE 4

GETTING STARTED

Always remove the Processing Carafe when filling.
When filling the Processing Carafe, do not overfill, as this may
adversely affect performance of the unit.
Plug unit in a three prong outlet. For your safety please do not modify!
USE ONLY WITH MICROBIOLOGICALLY SAFE WATER FROM A
KNOWN SOURCE! Your lotus® Water Treatment System is not
intended for the treatment of water that has an obvious contamination
source, nor is it intended to convert wastewater into microbiologically
safe water.*
The unit is pre-programmed at the factory for municipal water. To
verify that this mode has been set. Plug in the electric cord and ensure
that the status indicator light is off.
5