Checking Battery Status; Operating Your Radio - Fm; Using Preset Stations - Festool SYSROCK BR 10 Manual De Instrucciones

GB
BR 10

For a better sound quality using
an external device, adjust the
volume on the external device
to maximum 70%.
5.5

Checking battery status

To check the current battery level,
press the power button [1-5] to
switch on the radio. The battery sta-
tus indicator [e] will show the current
battery level (only with Li-Ion battery
pack).
Battery is fully charged
Battery is partially
charged
Battery low - charging
required
battery critical - alterna-
tive power source
required immediately.
5.6

Operating your radio - FM


Straighten up the antenna [1-3].

Press the source but-
ton [j] until the FM mode
is selected.
FM auto-tune

Press and hold (~1 sec.) the Tuning
control [i], [h] to carry out an auto-
tune.
Your radio will stop scanning when it
finds a station of sufficient strength.
18
The display will show the frequency
of the signal found. If the signal is
strong enough and there is RDS data
present, the radio may display the
station name, radio text and clock
time.
Finding other stations

Press the Tuning control [i], [h] as
before.
When the end of the waveband is
reached, your radio will restart tun-
ing from the opposite end of the
waveband.

If you find that FM reception is
poor, try repositioning the an-
tenna.
Manual tuning -FM

Press the Tuning control [i], [h] to
tune to a station.
The frequency will change in steps of
0.1 MHz.
5.7

Using preset stations

You may store your preferred FM ra-
dio stations to the preset stations.
There are four memory presets in
your radio.

Press and hold (~1 sec.) the Preset
button [b], [c], [f] or [g] until the
display show <SET MEMO>.