Festool SYSROCK BR 10 Manual De Instrucciones página 21

rarily mute their Bluetooth audio
streaming when they receive text
messages, emails or for other
reasons unrelated
streaming. Such behaviour is a
function of the connected device
and does not indicate a fault with
your SysRock.
Playing previously-paired devices
This unit can save up to 8 sets of
paired devices. When the amount is
exceeded, the earliest device will be
over written. If your Bluetooth device
has already been paired with the Sys-
Rock previously, the unit will recog-
nize your Bluetooth device and will
automatically attempt to reconnect
with the device it was last connected
with. If the last connected device is
not available, the SysRock will try to
connect to the second last device, and
so forth.
Deleting Bluetooth device pairings

To delete all Bluetooth device pair-
ings, press and hold the Preset 4
button [g]
shows on the display. The SysRock
will turn off automatically after the
memory is cleared.
to audio
until <BT-RESET>
Disconnecting your Bluetooth device

Press the Source button [j] to se-
lect any mode other than Bluetooth
mode.

Alternatively, press (~2 sec.) the
Bluetooth pair button [f] to discon-
nect the link.
If you disconnect the Bluetooth de-
vice when you are in Bluetooth mode,
the Bluetooth icon will then start to
flash, indicating Bluetooth is avail-
able again for pairing.
Using your hands-free call feature
Your unit can be used as a
hands-free accessory for
your phone. When music is
playing through your SysRock and
you receive a call on your phone it can
pause the music automatically to al-
low you to answer your phone.

If you receive a call while playing
music through your SysRock, press
and release the Call button [c] to
answer your phone call.

Speak in direction of the built-in
microphone [1-7].

Note that a very high volume
setting may decrease sound
quality.

Press and release the Call button
[c] to end the phone call.
GB
BR 10
21