Haier HLP21N Manual Del Usuario página 12

English
Installing the Bottom Panel
The bottom panel blocks noises to provide you with the quietest performance
possible during the wash cycle operation.
1. First, lay down the washer on its front side.
2. Place the panel against the bottom of the machine.
Align the holes in the panel with the holes in the
washer.
NOTE: Please ensure that the bottom plate
is positioned properly before permanently
screwing to bottom of the washer.
The side marked "face to floor" must be
facing you when putting the screws in.
The end marked "front" must be aligned
with front of the washing machine.
WARNING: Not facing the bottom plate properly or aligning the bottom
plate to the front of washer will cause damage to washer!
3. Insert the screws through the holes of the panel into the bottom of the washer
and tighten. (6 screws are supplied.)
4. Once all screws have been installed and the panel is in place, return the
washer to its standing position.
Note: During this time, you may reroute the drain hose to the left or right side
for draining. Just remove hose clamp and snake to other side, then
re-insert hose to other side.
11
FRONT
FRONT
FRONT
FACE TO FLOOR