Altrad BELLE TDX 650 Manual Del Operador página 25

Having carried out the checks listed in the 'pre start' section, you may start the engine.
pump.
As the engine speed is increased the clutch will engage and the engine will drive the Hydraulic Pump to send the hydraulic
power to drive the drums, and to drive the vibration mechanism as well. To avoid any damage to the centrifugal clutch, move
the throttle lever quickly from L to H position. For correct operation, the engine speed should be set to maximum during the
compaction operation
components will be damaged, and the life of the machine will be greatly reduced.
When working on a steep slope, pay extra care in operating the machine so that the machine roll down the slope.
Always work up or down the slop. Do not work across the slope. If the machine is parked on a slope, always apply the Parking
Brake Lever.
When the machine is going in reverse, make sure not to stand behind the Operation Handle. Always walk along the Operation
Handle and face toward the direction of travel.
Lifting
TRANSPORTATION
Transportation on a vehicle.
the vehicle.
Maintenance
regular maintenance listed in this section is carried out. It is recommended that an approved ALTRAD Belle dealer carries out all major
maintenance and repairs. Always use genuine ALTRAD Belle replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine and remove Key from the Key Switch
Servicing the Engine
Refer to the engine operation and maintenance manual.
Note:
machine with guards removed.
Maintenance: Every 8 hours or daily
Operating the TDX 650 Roller
Servicing
25
DO NOT restart the