Technical Data - Cooper Crouse-Hinds C30 Serie Instrucciones De Uso

1. Safety Instructions
For skilled electricians and instructed
personnel in accordance with national
regulation, including the relevant standard and,
where applicable, in acc.with IEC 60079-17 on
electrical apparatus for explosive atmospheres.
¡The boxes must not be operated in
Zones 0 and 20!
¡The tecnical data indicated on the
boxes are to be observed!
¡Changes of the design and modifications to
the boxes are not permitted!
¡The boxes shall be operated as
intended and only in undamaged and
perfect conditions!
¡Only genuine Cooper Cr Cooper Crouse-Hinds, S.A. Cooper Cr Cooper Cr Cooper Cr
spare parts may be used for replacement!
¡Repairs that affect the explosion protection,
may only be carried out by
Cooper Cr Cooper Cr Cooper Cr Cooper Crouse-Hinds, S.A. Cooper Cr ouse-Hinds, S.A. ouse-Hinds, S.A. ouse-Hinds, S.A. or a qualified ouse-Hinds, S.A.
"electrician" and will subsequenctly have to
be cheked by an "expert"!
Do not keep these operating instructions
inside the boxes during opertion.
¡The national safety rules and regulati-
ons for prevention of accidents and the
following safety instructions which are
marked with an ( ) in theses operting
instructions, will have to be observed!
2. Conformity with standards
This explosion protected boxes meets the
requeriment of IEC 60079-1, IEC 61241-1 and
EN 60439-1. It also complies with
the EC Directive for "Apparatus and protective
systems for use in explosive atmospheres" (94/9/EC).
It has been designed, manufactured and tested in
accordance to the state of the art and according to
EN29001 (ISO9001).
The boxes are suitables for use in explosive
atmospheres,Zone 1 and 2 acc. to IEC 60079-10-1
and Zones 21 and 22 acc. IEC 60079-10-2.

3. Technical data

Application: II2GD
Clase I: Exd IIC T6
Clase II: Ex tD A21 IP 67 T85º C
Certificates: KEMA 09 ATEX 0110X
IECEx - BKI 07.0026
Others, contact us
Serie of types: See Table 1
Approval of the production
ATEX Quality assurance: LOM 02 ATEX 9040
Degré of protection: IP 67
Temperature of use: -50 o C to + 55
Material of enclosure: Metal aloy aluminium
without Cu, natural colour
Storage temperature in
original Packing: -50 o C a + 60
Entries of cables: See table 1
Dimensions: See figure 2
Rated voltage: See table 1
Notes:
6) Max. power disipated inside for T6/T85ºC, is the following:
Tamb. up to 40ºC; P máx. <35W
Tamb. up to 55ºC; P máx. <20W
4. Installation
¡The respective national regulations as well
as the general rules of engineering which
apply to the installation and operation of
explosion protected apparatus will have to
be observed.
Transport and storage of the boxes is
permitted in original packaging only!
Opening and closing the boxes
¡The opening of boxes always shall be
without voltage!
¡For safe use the boxes are well closed
when covers are completly threaded on the
boxes enclosure!
Dimensions for mounting: See figure 2
Accesories:
ouse-Hinds, S.A. ouse-Hinds, S.A. ouse-Hinds, S.A. ouse-Hinds, S.A.
Cooper Crouse-Hinds, S.A. Cooper Cr Cooper Cr
See Cooper Cr Cooper Cr
Cable entries
Mounting the selected cable entries
(cableglands or seals acc. needs) acc. type
and dimensions of the main conection
cable, following their manufacturer
instructions.
¡The cable entries devices has to be the
same protection mode than the enclosure
where they are mounting Exd IIC!
5. Taking into operation
¡Prior to operation check the luminaire for
its proper funtioning and installation in
compliance with these operting instructions
and others applicable regulations!
Only carry out insulation measurements between PE
and external conductor L1 (L1, L2, L3) as well as
between PE and N.
- measurement voltage: max. 1kV AC/DC
- min. insulation: 5 MΩ
Then the boxes have to be tightly closed.
6. Maintenance
¡Observe the national rules applicable to
maintenance, servicing, inspection and
repairing of apparatus for explosive
atmospheres, as well as the general rules of
6)
engineering!
6)
¡For dust explosive application, pay special
attention dont't have present clust layers
abore 5mm on side of the apparatus!
Servicing
¡The responsable of the safe use of these
apparatus is the property!
o C
When servicing, in particular those components that
affect the explosion protection , will have to cheked,
e.g.:
o C
The flameproof joint have to be clean,
undameged, without corrosion and perfect
greassed.
Gaskets for their perfect conditions.
Cable entries whitout corrosion.
Terminlas and blanking plugs for their firm fix.
ouse-Hinds, S.A. catalogue ouse-Hinds, S.A. ouse-Hinds, S.A.
ouse-Hinds, S.A.
¡The flameproof of these apparatus have to
be greassed permanentlly in order to ensure
it protection in front of the corrosion, water
ingrees and seize-up problems. Cleaning
rest of greasse and corrosion no using
sharp metallic devices who can damage the
surface of the joint, and greasing they using
apropiate greasse thermically and
chemically stable, like e.g.: Molikote
BR2 plus.
Inspection
¡The nationals regulations have to be
observed!
E.g. in Spain the inspections of the installations in
hazardous areas, have to be done by "qualified"
personnel in accordance with the Electrotechnical
Low Votage Regulation following the indications
stablished in IEC 60079-17.
¡When the inspections are in degree of
"Detailled" or "Closed", the luminaires have
to be disconnected from the main conection!
Repairing
¡The nationals regulations have to be
observed. The tasks of repairing have to be
made by "qualified" personnel!
¡ The users are not authorized to repair this
sealed part!
¡All reparations have to be done without
voltage!
For repair electrical equipments in protection mode is
suggested follow the instructions indicated in
IEC 60079-19.
¡Only use genuine Cooper Cr Cooper Crouse-Hinds, S.A. Cooper Cr Cooper Cr Cooper Cr
spare parts!
Subject to alteration or supplement of this
product without any advertisement before.
Cooper Crouse-Hinds, S.A.
    
ouse-Hinds, S.A. ouse-Hinds, S.A. ouse-Hinds, S.A. ouse-Hinds, S.A.
5