HumanTechnik cm-1 Instrucciones De Servicio página 28

Inserting the battery into the CM-1 receiver:
The device runs on a rechargeable "AAA"-type battery. Where necessary, only
use original replacement batteries.
It can also run on a non-rechargeable battery. If you run your CM-1 communica-
tion system on disposable batteries, don't place the receiver onto the CM charger.
Ensure that the battery is placed the right way around into the bat-
tery compartment. The stipulated installation direction is indicated
on the bottom of the battery compartment.
N.B. This battery is not adequately charged upon delivery and has
to be charged fully on the CM charger first of all.
1. Switch off your CM-1 receiver.
2. Remove the battery compartment cover from your CM-1 receiver.
3. Place the supplied battery into the battery compartment (note the polarity!).
4. Place the cover onto the battery compartment.
5. Place the CM-1 receiver into one of the CM chargers.
The right-hand LED on the CM recharger lights up in red during the entire char-
ging process. After 10 hours, the battery is fully recharged and the LED now
lights up in green.
28 English