Troubleshooting - Clevo P570WMx Manual Del Usuario

Troubleshooting

Problem
The Bluetooth module is off
after resuming from Sleep.
No sound can be heard
through an HDMI connected
display device.
I have installed the Windows
operating system but cannot
hear any sound.
The computer is off (or in
Sleep Mode) but powered by
the AC/DC adapter plugged in
to a working outlet or powered
by the battery with a capacity
level above 20%. I have
plugged a device into the
powered USB port in order to
charge it, but the device is not
charging.
The Bluetooth module's default state will be off after resuming from the Sleep power-saving state.
Use the key combination (Fn + F12) or touch sensor instant key
module after the computer resumes from Sleep.
You have not configured the HDMI audio output. See
The audio driver is not installed. Install all the drivers as instructed in the section
Installation" and make sure you install the audio driver.
The port is not powered on. Toggle power to the port using the Fn + power button combination.
This function may not work with certain external USB compliant devices (check your device's
documentation). If this is the case, power the computer on and connect the external USB
device in order to charge it.
Possible Cause - Solution
"Audio Setup for HDMI" on page
to power on the Bluetooth
24.
"Driver
35