Cleaning And Care - Springlane Mia Manual De Instrucciones

Press the operating button again once to prematurely terminate the
programme – the device will stop immediately.
Attention, the container is very hot after heating milk –
danger of burns!
NOTE: Overheating protection
The built-in overheating protection monitors the motor and appliance temperature.
If milk has just been heated, it is not possible to restart the stirring and heating
process immediately. The appliance must first cool down somewhat before it can be
used again.
If the filling quantity is too low, the overheating protection can automatically switch
the motor off. Therefore, always pay attention to the minimum and maximum filling
capacities (100-250 ml).

CLEANING AND CARE

After each use, the appliance should be cleaned and dried as follows.
Insufficient or improper care of the appliance may affect the performance
of the milk frother.
Allow the milk container and heating plate to cool down completely after
use and before each cleaning to avoid burns.
For reasons of electrical safety, the base station, mains power cord, and
appliance plug must not come into contact with water, and by no means
be immersed in liquid.
• Use a sponge or soft brush and rinse with warm water and a small quantity of
mild detergent to clean the inside of the milk container.
• Do not use scratching or abrasive cleaners, hard brushes, and steel wool sponges
to protect the material and the heating element from scratching.
• Turn off the appliance before cleaning the base station and unplug the power
31