Cordivari My Way Instrucciones De Uso página 15

A. House creation.
See house creation section.
B. Radio pairing.
See radio pairing section.
C. Delete a device:
Select device type and then the device.
D. Delete all devices:
All devices installed in the system will be deleted (rooms will be main-
tained).
E. Identify a device
To identify a device of the installation
a To put the menu in reception mode.
b To access to the device parameters.
Proces:
- Press on 'a' to make the Central listening
- Press on the device receiver and wait a few seconds until radio com-
munication frame is transmitted.
Note: ID-number is displayed on the screen, please repeat to
be sure to have the same ID.
- Long press on to change device parameters (name, power ...).
F. Antifreeze setpoint:
You can set the antifreeze setpoint as reference for the whole installation,
to prevent pipe freezing and protect the system in winter period.
Cod. 1910000000259 - nv00
I
J
b
a
- 15 -
G. Heating settings:
You can limit temperature (min/max) and fix a setpoint on each thermo-
stat per zone.
H. WIFI settings:
To set the WIFI configurations (SSID/Protected Access Key Type/ Pass-
word). You can do it manually or scan the active networks.
Configuration requesting a registration on a web page is not supported.
WIFI Status:
0/2: Central unit not connected to the wifi router and server
1/2: Central unit connected to the Wifi router
2/2: Central unit connected to the wifi router and to the server (Pairing of
the central to an account is required)
Note: The connection to Internet is recommended with Certified
WiFi routers (http://www.wi-fi.org/certification).
Note: Automatic pairing time to WiFi router with WEP key: 3-4 min,
with WPA2 key: 1 min.
Note: For the network scan, Repeat at least twice the operation if
your desired WiFi network is not displayed. If your desired
WiFi network is still not displayed, enter the WiFi settings
manually
I. General factory default:
To reset the system with the factory values, but the software version will
remain the same.
J. Update Firmware:
New version of the firmware are available on www.cordivari.it. You can
download and unzip files by PC on a SD-card (less than or equal to
16GB). Place the SD-card in the unit (there is a slot on the side).

Select to proceed.
Please wait the end of the update procedure (The Wifi icon should be
available for the Wifi central unit) before removing the SD-card from the
central unit.
10.Heating devices management
For setting follow procedure: press on
selecting the room, press on
1
2
3
4
12
1. Device type choice : Heating device
2. Device type choice : On/off plug device
3. Device type choice : Electrical radiator device
English
1 2 in the main screen and after
3 4
10
13
9
7
10
8
5
12
6
11