Kamikaze KV 3 Manual De Uso página 64

ELECTRONIC TYING MACHINE
• Charger design for use only indoor. Charging operations have to be
performed indoor.
• Disconnect power before to clean the charger to avoid damage and risk
of electrical shock.
• Don't expose battery in strong light. Don't put battery on hot surface. It can
cause battery explosion.
• Fully cold battery before charging.
• Don't disassemble the battery, don't damage battery, in order to avoid injury.
• When not used the battery have to be recharged at least every 3 months,
otherwise it will be damaged. The warranty will not cover damages
caused by the missed respect of charging frequency.
4.4 USE CHARGER CORRECTLY
• Use the charger only with rechargeable battery. If not it can cause fire or
explode. Use original charger to keep safety.
• Always check charger, wire and plug before use. If damaged, please move
to Customer Assistance Service to repair. Don't use damaged charger,
don't repair by yourself, this will keep the tool safe.
• Check voltage of charger match the battery value, if not may injury
yourself.
• Disconnect the charger before switch on/off tool with connected battery
and equipment.
• Keep charger clean, away from drippy or rain environment. Don't use the
charger outdoor, dirt or water can cause injury.
• The charger is designed for original battery only. Otherwise may be cause
damage or fire.
• Avoid damaged charger will reduce injury.
• Don't use chargers on tinder surface (e.g. paper or dry goods).
• The battery is not fully charged when you buy it, you must charge
4-5hours before first use the tool. Connect the battery to charger before
power on.
• Normal charging time is 4-5hours, don't charge the battery for too long
time, it will damage the battery. Make sure charging at indicate just 1 LED
light, this will ensure at battery life.
64
www.kamikazevolpi.com