Technical Data - AEG MRC 4141 P Instrucciones De Servicio

English
68
• Press the NAP/M+ /MEM button repeatedly (6) to select the time after which the
device will beep. Select from 90 to 10 minutes or OFF (off) in steps of 10 minutes.
• After the selected time has elapsed, an increasingly fast beep will sound. Use the
button (5) to turn off the beep.
Projection
With this unit, you can project the time onto a wall or the ceiling.
• You can switch this function on and off with the ON/OFF / PROJECTION button (17).
• Rotate the projector (16) to the desired position.
• A dial located on the top of the projector can be used to adjust the sharpness of the
projected display.
• You can use the 180° FLIP button (18) to flip the projection by 180 degrees.
Cleaning
CAUTION:
Do not dip the appliance in water.
• Remove the plug before cleaning.
• Clean the appliance with a slightly humid cloth without any additives.
Troubleshooting
Problem
The unit cannot be
operated

Technical Data

Model: ................................................................................................................................. MRC 4141 P
Power supply: ....................................................................................................................230 V~ 50 Hz
Power consumption:.........................................................................................................................5 W
Battery power reserve: ...................................................................................................... 3 V, CR2032
Protection class: ......................................................................................................................................II
Net weight: ................................................................................................................. approx. 0.467 kg
Cause
The unit is blocked and
"hangs"
Solution
Pull the mains plug out for about
5 seconds. Then turn the device on
again.