Orbegozo MIG 2527 Manual De Instrucciones página 39

MIG 2527
Turntable Installation
Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly
Installation and connection
1.This appliance is only intended for domestic use.
2.This oven is intended for built-in use only.It is not intended for counter-top use or for use inside a cupboard.
3. Please observe the special installation instructions.
4.The appliance can be installed in a 60cm wide wall-mounted cupboard(at lease 55cm deep and 85cm off the floor).
5.The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.
6.The mains voltage must correspond to the voltage specified on the rating plate.
7.The socket must be installed and connecting cable must only be replaced by a qualified electrician.If the plug is no
longer to accessible following installation,an all-pole disconnecting device must be present on the installation side with
a contact gap of at lease 3mm.
8.Adapters,multi-way strips and extension leads must not be used. Overloading can result in a risk of fire.
a. Never place the glass tray upside down. The glass tray should never be
restricted.
b. Both glass tray and turntable ring assembly must always be used during
cooking.
c. All food and containers of food are always placed on the glass tray for
cooking.
d. If glass tray or turntable ring assembly cracks or breaks, contact your
nearest authorized service center.
The accessible surface may be hot during the operation
39