Power Supply - palintest PAASense Manual De Instrucciones

23
Technical Specification – Sensors
Sensor Type Disposable, single-use, chronoamperometric
Calibration Pre-calibrated during manufacture
Packaging
Individually packed in sealed foil
Sensor Storage
Life
Sensor Storage
< 4° C (39° F) for over 1 year
< 20° C (68° F) for less than 1 year
Temperature
Calibration Check Standards
Only Palintest PAASense Check Standards (CS181) can
be used with this instrument.
Guarantee
The Palintest PAASense is guaranteed for a period
of 2 years from the date of purchase. This excludes
accidental damage or damage caused by unauthorised
repair or misuse. Should repair be necessary, contact
our Sales Department quoting the serial number shown
on the instrument label. This guarantee does not affect
statutory rights.
sensor
2 years

Power Supply

The PAASense operates on alkaline batteries.
the instrument features an automatic battery
condition check as part of the analysis cycle. If the
batteries need replacing a 'Low Battery' warning
message appears. The message can be cleared by
pressing enter.
When the Low Battery warning appears the instrument
continues to function correctly for several tests, but the
batteries should be replaced as soon as possible.
The battery compartment is in the base of the
instrument and is secured by four screws. To replace
the batteries, remove the cover, pull out the battery
pack and remove the old batteries. Replace all four
batteries at once with fresh batteries, observing the
correct position as marked in the battery holder.
Insert the battery pack in the base of the instrument,
and replace the battery compartment cover. Tighten
the screws in diagonal pairs to ensure waterproof fit.
Use 4 x 1.5v 'AA' alkaline cells (type MN1500, LR6, E91
and AM3 or equivalent).
To avoid corrosion damage through leakage, remove
batteries from the instrument if it is to be stored or left
unused for a long period of time.
24