palintest PAASense Manual De Instrucciones página 9

13
Drying the
Electrical Connectors
The instrument is fitted with electrical connectors that
make contact with an inserted sensor. If the contacts
become wet, open the jaws with the blue lever and insert
a Palintest contact drying stick. Wait a few seconds until
it absorbs the water, remove and insert the opposite end
of the stick to check the contacts are dry. The 'Contact
Drying Stick' may also be used to clean the contacts.
Set-Up Mode
The PAASense is designed for simplicity of use in the
field. The user selectable options are only accessed when
linked to the PC. Once selections have been made, these
are stored in memory, and applied to each reading. The
instrument settings cannot be changed accidentally, or
without supervisor intervention.
1
To enter SET-UP mode, connect the instrument to a PC
via the USB port.
2
Press the power button.
3
Scroll through the menu of options using the up and
down keys. Press Enter to select.
Language
From set up mode, use the up and down keys to
highlight 'Language' and press enter to select to show
the available languages.
Scroll to highlight the required language.
Press enter to select and return to the options list.
Clear Log
From set up mode, use the up and down keys to
highlight 'Clear log' and press enter to select.
Use the up and down keys to highlight Yes or No.
Press enter to perform the action and return to the
options list.
Reset Sample
From set up mode, use the up and down keys to
highlight 'Reset sample' and press enter to select.
Use the up and down keys to highlight Yes or No.
Press enter to perform the action and return to the
options list.
14