Troubleshooting; Specifications - Tanita IRONMAN InnerScan 50 Manual De Instrucciones

Troubleshooting

If the following problems occur ...then...
• A wrong weight format appears followed by kg, lb, or st-lb.
Refer to Switching the weight mode on p.3.
• The display shows and goes off when the personal key pressed.
No data (age gender, height and activity level) has been stored in the memory.
• appears on the display, or all the data appears and immediately disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the
accuracy of your measurements. Change all the batteries at the same time with new batteries.
Note : Your settings will not be erased from the memory when you remove the batteries.
• appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
• The Body Fat Percentage reading does not appear or
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the
measuring platform.
• appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded
• No reading is obtained after pressing a feature button.
Step off scale when body fat reading appears, then press feature button.

Specifications

BC-350
Weight Capacity
330lb (150kg) (23st 8lb)
Weight Increments
0.1lb (0.05kg) (0.1lb)
Body Fat Increments
0.1%
Personal Data
4 memories
Power Supply
2pcs.Lithium batteries CR2032 (included)
Power Consumption
15 mA maximum
Measuring Current
50 kHz, 500 µA
appears after the weight is measured.
Federal Communications Commission and Canadian ICES Notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and Canadian ICES-003. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by Tanita Corporation may void the user's authority to operate the
equipment.