Using The Heater - Toolland FT5130 Manual Del Usuario

4. Features
 infrared ceramic heater with thermocouple safety and tilting reflector
 for outdoor use
 mounting bracket
 can be used with butane and propane gas
 compact design
5. Operation
5.1 Installation
1. Make sure all components are standing safely.
2. Use a clamping screw to fix the holder on the bottle.
3. Screw the pressure controller and the gas hose on the valve of the gas cylinder.
4. Use the butterfly nut and the chrysanthemum gasket to put the heater to the required position. Fix it on the
stand.
5. Screw the other end of the gas hose to the safety valve. Make sure all the screws are tight.
5.2 Connection to the Gas Cylinder.
Keep the gas cylinder and heater away from any open flames.
1. Use an approved regulator and a gas hose with a length between 40 cm and 50 cm. Avoid twisting the
hose.
2. Slowly turn on the regulator and check if there are no gas leaks. To do so, brush some soapy water on all
connections.
Before putting the device into operation, check for gas leaks at the screwcaps using a detection
spray or soapy water. Retighten them if necessary.
5.3

Using the Heater

Never aim the heater at the cylinder. The hose must always trail at the rear of the heater.
Never separate a switched-on heater from the gas cylinder.
start/position 1 (high)
1. Make sure the heater has been assembled correctly.
2. Open the regulator to feed the gas.
3. Turn the control knob to position 1 and hold pressed. Activate the piezo igniter to create a spark. Keep
pressing the control knob for another 10 seconds.
4. Turn the control knob to position 2 to adjust the flame.
5. To turn off the heater, interrupt the gas feeding by closing the regulator. Once the flame has died out, turn
the control knob back to position 1.
V. 01 – 07/07/2015
FT5130
4
position 2 (low)
©Velleman nv