Preparations; Inserting A Battery; Hold Switch - Aiwa MM-FX500 Instrucciones De Manejo

PREPARATIONS

Inserting a battery

Alkaline batteries are recommended for use
with this unit.
1 Open the cover of the battery
compartment.
2 Insert an LR6 (size AA) alkaline battery
with the 0 and 9 marks correctly
aligned, then close the cover.
Battery Indicator
The battery indicator shows the power
remaining.
Full
When flashes on the indicator,
replace the battery with a new one.
Notes
• Make certain the battery is fitted in the
correct direction (0 and 9 aligned).
• Do not attempt to recharge, to
disassemble or to apply heat to the
battery. It may cause electrolyte leakage
or an explosion.
• When the unit is not in use for a prolonged
period, remove the battery from the unit
to save battery power.
• If liquid leaks from the battery, wipe it
thoroughly.

Hold switch

When operating with the main unit, set
the HOLD switch on the main unit to the
unlocked position.
When operating with the remote control,
set the HOLD switch on the remote control
to the unlocked position.
Empty
When not using the unit, set both HOLD
switches to the hold position. This is to
prevent accidental operation during
transportation.
When the main unit is set to hold position,
the HOLD indicator appears on the display.
Hold
Unlocked
Hold Unlocked
ENGLISH
7