Handling Electrical Components; Electrical Connection; Charging The Batteries; Preparing The Bath - Rotho BABY SPA WHIRLPOOL Instrucciones De Uso

2.4 Handling Electrical Components

Please observe the following precautions and safety instructions:
• Never immerse the plug, cable and outer side of the whirlpool tub
in any liquid (the whirlpool tub is not designed for use in water).

2.4.1 Electrical connection

• Your Baby Spa Whirlpool tub is equipped with a power pack enabling its operation in all of
Europe (except the United Kingdom, Ireland, Cyprus and Malta).
• When using this power pack, your Baby Spa Whirlpool tub is supplied with a safe voltage of 12 VDC.
• Never touch the electrical connectors with wet hands.
• Before operation or charging, connect the connector of the equipment in the respective
opening at the bottom of the tub.
• Connect the mains plug only to a mains socket properly installed in compliance with the regulations!

2.4.2 Charging the batteries

• Connect the equipment to a wall socket using the power pack. After 60 seconds, the status
display in the control panel will automatically change from a green continuous light to a red
flashing light. The battery is now charging. A charging process is complete after approx. 6 hours.
• The charging process can be interrupted at any time by pressing a function button.
The whirlpool is then in operating mode. The battery is not charged during operation.
• Once the charging process is complete, the status display changes to a red continuous light (see 2.6.1).
• Once the charging process is complete, unplug the power pack from the wall socket
(Caution: pull at the plug, not at the cable).
• When disconnecting the cable from the equipment, please pull at the cable because it is a special
connector protected against splash water.

2.5 Preparing the Bath

• Please observe all warning notes listed in these Instructions for Use.
• Check that both the outer and inner bottoms of the tub are clean and not slippery.
• Before bathing, please remove any bathing residues using a cleaning agent with
neutral pH and water and then rinse with clean water (see 2.9.1).
• Please complete the disinfection procedure before every 3rd bath. If the bath
has not been used for more than 3 weeks, it also needs to be disinfected before
the next use (see 2.9.2). Ensure an agreeable room temperature and prepare
all needed items so that you have them within your reach. Ensure a relaxed
and calm atmosphere (e.g. switch o your mobile phone, phone and doorbell).
• Fill the tub with warm water up to the "MAX" level
marked on the side of the tub.
• Please make sure that the water is not too hot.
The temperature should not exceed 99°F (37°C).
TIPP:
We have prepared a film for you to watch on the Internet that contains
important instructions on how to bath your baby correctly: www.rotho-babydesign.com
15