Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42

2.9.2 Disinfection

Caution: Never put the baby into the disinfecting bath!
Caution: Keep the whirlpool tub out of the reach of children during disinfecting!
To ensure hygienic safety of the children's bathtub it is necessary to perform chemical
disinfection using the supplied disinfectant (for re-orders see 8) according to the
following schedule:
• Please disinfect the tub before every 3rd bath. If the bath has not been
used for more than 3 weeks, it also needs to be disinfected before the
next use.
• For the disinfection, fill the baby bathtub with water to 2 inches (5 cm)
above the "MAX" indication. Then add approximately 0.6 ounces / 18 ml
or 4 caps of Koller-disinfectant in the whirlpool.
• Activate the disinfection mode.
Disinfection mode
• Press both air buttons simultaneously and hold for 3 seconds.
This mode is indicated by red flashing of the colour light.
• The air massage will automatically be run alternately for 30 minutes.
Once disinfection is complete, the colour light changes to a blue continuous light.
• Press the colour light button to confirm the end of the disinfecting cycle and to switch
o the colour light.
• The disinfection mode cannot be interrupted.
• Upon completion of the disinfection mode, the tub can be emptied into the bathroom outlet.
Use the supplied draining tube.
Next, perform the cleaning procedure (see 2.9.1) to remove any disinfectant residues!
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

20306 0001 01

Tabla de contenido