Part Names; Connections; Installation - Panasonic RP-WFG20 Instrucciones De Funcionamiento

Part names

See illustrations on page 2.
Bone conduction headphones
In-Ear type headphones
Left speaker
Right speaker
Earpieces
(Only for In-Ear type headphones)
Arm
Connection plug
Receiver
Receives signals from the transmitter. Connected to
headphones.
Front panel
Reset switch
OPR (operation) indicator (→ page 9, 10, 11)
● Lights up in red when the receiver is turned on.
● Lights up in green when enhancing speech is
on.
● Goes out when the receiver is turned off, and
when the receiver has not received audio input
for approximately 1 minute (AUTO OFF).
Headphones release buttons
Headphones connection jack
● Do not connect any other headphones except
the supplied ones.
Charging terminal
Rear panel
ENHANCING SPEECH button (→ page 10)
VOL (volume) button +/-
Use this to adjust the volume level. (→ page 9)
BALANCE control L/R (→ page 9)
POWER /TUNING button (→ page 9, 10, 11)
Transmitter
Transmits signals to the receiver.
Front panel
OPR/CHG (operation/charging) indicator
(→ page 8, 9, 10)
● Lights up in red when charging the receiver.
● Lights up in green when the transmitter is
operating.
● Goes out when charging is completed, and
when the transmitter has not received audio
input for approximately 3 minutes (AUTO OFF).
Charging terminal
Rear panel
AUDIO input plug
Used to connect to the audio terminal on the audio-
visual equipment.
DC IN 12 V terminal
Used to connect to the supplied AC adaptor.
CHANNEL switch (→ page 10, 11)
8
20

Connections

See illustrations on page 3.
1. Connect the transmitter to the audio-visual
equipment.
The audio input plug
be connected directly to the 3.5 mm stereo mini
headphones jack on your equipment
Portable CD player, headphones stereo, radio/tape
players, personal computer, etc.
OR
Use the supplied adaptor cord
the transmitter to the audio output stereo pin
terminals on your equipment
Amplifier, TV set, video deck, cassette deck, DVD
player, etc.
● Do not use any other adaptor cord except the
supplied one.
2. Connect the supplied AC adaptor to the
transmitter, and then to a household mains
socket.
(AC 230 V - 240 V, 50 Hz)
Disconnect the AC adaptor from the household mains
socket if the unit is not going to be used for a long
time.
The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is always
"live" as long as the AC adaptor is connected to an
electrical outlet.
● Do not use any other AC adaptors except the
supplied one.
Note
● [OPR/CHG] indicator lights in green when the
transmitter receives audio signals. It does not light
just by connecting the transmitter to an AC power
source.
● Use the 6.3 mm stereo standard plug adaptor (not
supplied) if the headphones jack is large (6.3 mm
stereo).

Installation

This unit uses radio waves.
The waves can be transmitted to a range of up to 100
meters.
Note
Under optimum conditions, the headphone unit can pick
up clean signals from the transmitter to a maximum of
100 meters. Metal between the two units and the pre-
sence of other radio waves may cause interference
to occur at a shorter distance. This interference can
be cleared by moving closer to the transmitter, removing
the obstructions, or changing the transmitter channel.
You may occasionally experience interference due to
dead spots in the area covered by the transmitter. This
phenomenon occurs with any kind of radio signal and is
not a malfunction. Dead spots can be moved by moving
the transmitter and the headphone unit.
of the transmitter can
.
to connect
.