Craftsman 917.881051 Manual Del Usuario página 10

OPERATION
GASOLINE ELECTRIC AUGER
START BUTTON CONTROL
LEVER
RECOIL
CHOKE
CON-
TROL
STARTER
HANDLE
CHUTE
DEFLECTOR
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED DEFLECTOR REMOTE
CONTROL LEVER CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
SAFETY
IGNITION
KEY
ON / OFF
SWITCH
CHUTE
LH TURN
TRIGGER
LIGHT
CLEAN-OUTTOOL
KNOB
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
\
\
TOOLBOX
/
DRIFT CUTTER
PLATE
AUGERS
FIG. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, Iocknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle- used for starting engine.
Primer - pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
LH and RH turn triggers- used to steer the snow thrower.
10
Drive speed control lever - used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever- used to engage power-pro-
pelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion
(throw snow).
Discharge chute control lever - used to change the
direction the snow is thrown.
Deflector remote control lever - used to change the
distance the snow is thrown.
Skid plate- used to adjust height of scraper bar from ground.
Drift cutter - used to cut through deep snowdrifts.