OPERATING INSTRUCTIONS
1. POWER ON/OFF
By pressing this key, the unit is switched on and off.
This unit is turned on by pressing any key.
2. SELECT
3. VOLUME UP/DOWN
Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To
select other functions, press the SEL (2) button shortly until the desired functions is shown
on the display. Figure 1 shows how control functions are selected using the SEL button.
1. VOL
2. SEL
Turning the VOL knob Right or Left. Increase or decrease the volme by turning
These buttons can be used to adjust the BASS, TREBLE, BALANCE and FADER.
AUDIO DSP CONTROLS (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of
these function.
2 sec.
SEL
DSP
ESP MODE (2)
When press the SEL button for more than 2 seconds, it is activated as 12 sec. or 45 sec. of
ESP mode can be selected.
2 sec.
SEL
DSP
MULTI CD SECTION MODE (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of
these function.
2 sec.
SEL
DSP
CD MULTI ON/OFF mode is selected by
section CD. CD MULTI OFF: Read first section only.
BEEP MODE (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of
these function.
2 sec.
SEL
DSP
BEEP ON: BEEP sound can be heard from speaker when the buttons are pressed.
1
2
3
Fig. 1 Selection of sound control functions
3. BAS
POP M --- ROCK M --- CLASS --- FLAT M --- DSP OFF
VOL
SEL
ESP
VOL
SEL
ESP
SEL
ESP
SEL
SEL
2
4
2
4. TRE
5. BAL
ESP 12s. / 45s.
MULTI
CD MULTI ON/OFF
VOL
or
VOL
VOL
MULTI
SEL
E-4
5
2
6
6. FAD
key. CD MULTI ON: Read multi
BEEP
BEEP ON/OFF
VOL
2
or
.
VOL
VOL