Targa TAG-7000 Manual De Instrucciones página 6

SEEK MODE (2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of
these function.
2 sec.
SEL DSP
SEEK 1: When SEEK 1 mode is activated, AUTO SEEK SCAN is stopped when station is
detected even user still push SEEK button.
SEEK 2: Auto SEEK SCAN is not stopped even station is detected if user push SEEK
button. When release this SEEK button, then stop when station is defected.
4. PRESET STATIONS
Six numbered preset button store and recall stations for each band.
Storing a station:
1. Select a band (if needed)
2. Select a station
3. Hold a preset button longer than one second. Preset station number appears in the
display when station is saved.
Recall a station:
1. Select band (if needed)
2. Press a preset button for less than one second to select stored station.
5. STEREO/MONO SELECTOR
When FM stations are weak and are disturbed, listening can be improved by selecting
MONO. Press the button once, reception will then be in MONO. Repress to go back to
FM-stereo mode, "ST" appears on the display.
6. LOUDNESS CONTROL
Press this button to operate. The bass and treble response will be boosted. Push this
button again to return the player to its normal operation. This function is useful when listening
at low levels. The loudness control will boost the bass and treble response thus giving a
more lively performance.
While this function is operating, the display shows "LOUD".
7. LOCAL/DISTANT BUTTON
Press this button to select "Local" position in areas with strong signals to let radio stop at
only strong stations during manual tuning (LOC appears). Press to Distant position in areas
with weak signals to listen to all stations.
8. DISPLAY BUTTON (Set the Clock)
Selects radio frequency or clock display.
To set the clock:
1. With clock display selected, hold down (DISP) button until clock display starts flashing.
2. Rotating
VOL
3. Press (DISP) button to start clock.
9. MODE BUTTON
By pressing this key, user can select. AUX/TUNER/CD-MP3/USB or MMC/SD mode.
10. BAND SELECTOR SWITCH
Push this switch to select the desired band. Selection is made in regular sequence as FM1-
FM2-FM3-AM1-AM2.
SEL ESP SEL
to change minutes,
MULTI SEL BEEP
to change hours.
VOL
E-5
SEL SEEK
VOL SEEK1 / SEEK 2