Troubleshooting; Disposal Of The Old Device - CASO DESIGN IceMaster Comfort 3305 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 68

17.2 Troubleshooting

Problem
"Add Water"
indicator is on.
"Ice full" indicator
is on
„add water" and
„ice full" are both
flashing
Ice cubes stick
together.
Ice making cycle
is normal but no
ice formed.
ATTENTION
► If above mentioned steps don't solve the problem, please contact your customer
service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the environment.
Therefore, do not put your old device into the non-recyclable waste under any
circumstances.
Possible cause
Lack of water.
Water tank is dirty.
Malfunction of waterpump.
Ice is full in basket.
Malfunction of sensors.
Ice basket is not placed
correctly.
The ice making cycle is too
long.
Water temperature in inner
tank is too low.
Room temperature or water
temperature in inner tank is
too high.
Not enough cooling agent in
the coolant reservoir or a
part of the electronics is
defect.
Solution
Stop the ice maker and press "on/off"button
again to restart the unit.
Clean the device.
Contact your customer service.
Remove ice from ice basket.
Carefully clean the sensors and restart the
device.
Check if the ice basket is blocked by
something and replace ice basket correctly.
Unplug mains plug and insert again, restart
the device.
Stop the ice maker and start it again when
the ice blocks are melt.
Replace the water. Temperature of water
recommended at 8-25°C.
The room temperature should be 10-32°,
water temperature should be 8-25°C.
Contact your customer service.
35

Publicidad

Tabla de contenido
loading

Tabla de contenido