Operation - LD Systems ICOA SUB Manual De Usuario

OPERATION

NOTE:
The LD Systems logo briefly appears on the display as soon as the speaker is correctly connected to the power supply and switched on. All settings
(e.g., Preset and Delay) resume the way they were as before the speaker was switched off. The speaker will be ready for use after completion of this
process, which usually takes one second.
MAIN MENU DISPLAY
The main display is activated during normal operation. It shows the master volume setting, the activated speaker preset, and the input levels of
channels 1 and 2 with peak display (see figure). Reduce the source device's output level (e.g., mixer) if the peak display shows that the input signal
is too high.
Volume control
Speaker preset
Input level with peak display
channel 1
VOLUME
From the main menu, the volume can be directly adjusted by turning the rotary-push encoder VOLUME / PUSH FOR MENU from -60 to +10 dB. When
the encoder is rotated, the display automatically changes to the corresponding symbol (see figure below). The main menu will automatically
reappear after approx. 20 seconds of inactivity. Pressing the encoder immediately changes the display to the main menu.
AUDIO SETTINGS (AUDIO)
Press the rotary-push encoder to access the main menu and then turn the encoder to select the menu item AUDIO (dark background). Press the
encoder again to access the submenu and then turn the encoder to select the desired submenu item. Confirm the selection by pressing the
encoder.
Refer to the table below for the submenu items and the relevant setting options.
SETTINGS (Change value or status = turn encoder, confirm value or status change = press encoder)
MAIN MENU
Return to main menu
PRESET
Selection of the speaker preset
DELAY
Time delay of the audio signal in 0.32 ft steps up to 32 ft (0 ft = OFF, display in meters and feet)
POLARITY
Sets the polarity
In the submenu, select MAIN MENU and press the encoder to return to the main menu. In the main menu, select HOME and then press the en-
coder to confirm this selection and return to the main menu. The main menu will automatically be displayed after approx. 20 seconds of inactivity.
Level
80 Hz Low-Pass Filter at 80 Hz
100 Hz Low-Pass Filter at 100 Hz
120 Hz Low-Pass Filter at 120 Hz
CARDIOID Preset for configuring two ICOA subwoofers of the same model as
a cardioid system. Rotate the subwoofer with the cardioid preset
180° and put it next to the main subwoofer. Then select the speaker
preset 100 Hz in the main subwoofer. The delay time, polarity, and
volume for the two subwoofers must all have the same setting.
NORMAL Normal polarity
INVERTED Inverted polarity
Input level with peak display
channel 2
Peak
7