How To Prepare The Machine For Operation; How To Install The Brush Or Pad Driver; How To Adjust The Handle - Clarke MP-1800 Instrucciones De Uso

EN

HOW TO PREPARE THE MACHINE FOR OPERATION

WARNING!
Always remove the electrical plug from the electrical outlet before
installing or changing the pad or brush.

How To Install The Brush Or Pad Driver

To install the brush or pad driver, follow this procedure:
1. Put the handle in the vertical position.
2. To lock the handle, push the locking lever down. See fi gure 1.
3. Tilt the machine backward until the handle is on the fl oor. See
fi gure 2.
4. Put one foot on each side of the machine. See fi gure 2.
5. Align the lugs (1) on the locking plate into the pad driver adapter
openings (2). See fi gure 3.
6. To lock the brush or pad into position, turn the brush or pad
driver as indicated in fi gure 2 (A).
7. To unlock and remove the brush, turn the brush or pad as
indicated in fi gure 2 (B).
8. Lift the machine to the vertical position.
NOTE: To prevent damage to the brush or pad driver, remove the
accessory while not in use. Keep the brush in a cool, dry place.

How To Adjust The Handle

To adjust the handle, follow this procedure:
1. The locking lever is on the lower part of the handle tube. Use
your foot to lift the lever.
2. Lower the handle to the best operating position.
NOTE: For the best operating position, keep your back straight,
bend only your arms.
3. Using your foot, push the locking lever down.
4. Hold the handle against your body for the best control.
-4 - FORM NO. 70193B
Figure 1
A
Figure 2
Figure 3
1. The lugs.
2. The drive adapter openings.
® Operator's Manual - MP-1800 Marble Polisher
Clarke
B
1
2