The Controls; How To Prepare The Machine For Operation - Clarke FM-1700HD Libro De Instrucciones

Figure 1
Figure 2
Apply pressure to lock
Aprete la palanca para
bloquear
Presser le levier pour
verrouiller
Figure 3
Figure 4
Page 10

THE CONTROLS

The Start/Stop Levers. See fi gure 1.
The Start/Stop levers are under the handle grips.
The Interlock Switch. See fi gure 2.
The interlock switch is on the handle assembly under the Start/
Stop levers.
The Locking Lever. See fi gure 3.
The locking lever is on the bottom of the handle assembly at the
back of the machine.
HOW TO PREPARE THE MACHINE
FOR OPERATION
WARNING: Always remove the electrical plug from
the electrical outlet before installing or
removing a brush or accessory.
To connect a brush or pad driver, follow this procedure:
1. Put the handle in the vertical position.
2. To fasten the handle, press down on the locking lever.
3. Put the handle on the fl oor.
4. Put one foot on each side of the machine. See fi gure 4.
5. Fit the lugs on the bottom of the machine into the openings
in the brush.
6. Turn the brush or accessory clockwise to lock it into posi-
tion.
7. Turn the brush or accessory counterclockwise to unlock
and remove the brush or accessory.
8. Lift the machine to the vertical position.
NOTE: To prevent damage to the brush or pad driver,
remove the accessory while not in use.
To connect a solution tank, follow the instructions given with the
tank.
Clarke ® Operator's Manual FM-1700HD HDTR