Publicidad
General information:
The outdoor fi replace/garden grillbar has to
be assembled on compacted, leveled ground
or concrete. Make sure there is sufficient
clearance (36 inches), between the unit and
fl ammable material. Step #4: the refractor base
is an option when grilling (can be omitted), but
is mandatory for wood burning.
Using the outdoor fi replace/garden grillbar:
Start the fi re with a small fl ame; if unit is
exposed to extreme heat too quickly, cracking
of the parts might occur. This is very important
if the weather condition caused the concrete
parts to become wet.
However, if cracks should occur, it would not
dimish the function of your outdoor fi replace/
garden grillbar, because all components are
metal re-enforced. The occurrence of hairline
cracks in the refractor parts are possible, but
do not constitute a claim.
Recommended burning materials:
The outdoor fireplace/garden grillbar is
made for usage of either charcoal or fi re
wood only!
Do not use more than 10 lbs of charcoal or
wood at one time!
Use only recommended starter fl uid or kind-
ling!
Do not use kerosene or gasoline, or similar
liquids to light the charcoal/fi rewood!
Attention:
Do not overheat the outdoor fi replace/garden
grillbar!
Assembly:
After you have levelly installed pedestal ele-
ment ➀, the rest of assembly is carried out
according to the drawing using parts ➁ - ➆.
Please make sure you follow this sequence!
All parts of the grillbar are to be connected
with the enclosed start-up adhesives, at least
locally. The adhesive needs ca. 24 hours until
completely set.
Please make sure the grillbar components
excepting cover plate ➆ are placed fl ush to
each other on the rear side. Cover plate ➆ is
mounted towards the rear with ca. 6-7 cm
overlap.
Disassembly:
A possible disassembly of the garden grillbar
is to be carried out in the reverse sequence.
Included:
1 bag of start-up adhesives
Cleaning:
The surface of your outdoor fi replace/garden
grillbar can be cleaned with either a high
pressure power washer, or diluted bleach and
coarse brush.
The copper/stainless steel hood, will show a
green patina after a period of time, which is
normal, but can be cleaned with copper or brass
cleaning material, if so desired.
English
Publicidad
