EHEIM incpiria 230 Manual De Instrucciones página 17

English
Installing inlet (⌦G)
1. Feed the inlet hose through the hole in the aquarium bottom and through the supply shaft.
2. Install the inlet. Please observe the operating manual, installation set.
Installing aquarium lighting (⌦H)
1. With the continuously adjustable pull-out brackets you can adjust the LED light g to the width of
your aquarium. To do this, pull the pull-out brackets out of the lamp housings in the desired length.
2. Place the LED light in the profile h on the front sides of the aquarium. Make sure that the LED light
is secure
3. Insert the LED light's power cable into the profile.
4. Feed the cable through the supply shaft into the base cabinet.
5. Connect the plug of the LED lights to the socket of the EHEIM power supply unit.
For maintenance work, the LED light can be pushed into the profile.
Installing cabinet lighting
1. Insert the cabinet lighting socket into the matching power supply unit. For this, heed the cabinet
lighting operating manual.
2. Insert the power supply unit's mains plug into the mains socket.
7. Operation
Filling the aquarium (⌦I)
CAUTION! Material damage.
▶ Do not use hard objects or cleaning agents for cleaning.
1. Before filling, thoroughly clean the aquarium with warm water and a soft, clean sponge.
2. Decorate the aquarium with gravel, stones, plants etc.
DANGER! Electrocution due to penetrating water!
The LED light is only protected against penetrating water if immersed temporarily.
▶ The distance from the underside of the light g to the highest water mark must be a minimum of
15 mm.
3. Fill the aquarium with water to a maximum of 85 mm below the upper edge i.
Switching the LED light on/off
1. To switch on the LED light, insert the power supply unit's mains plug into the mains socket.
2. To switch off the LED light, pull out the power supply unit's mains plug.
For a more comfortable switching on and off of the LED light we recommend a timer or individual pro-
gramming of the EHEIM LED controller.
17