English
‧ Repairs must only be carried out by an EHEIM service centre.
‧ Only carry out the work described in these instructions.
‧ Only use original spare parts and accessories for the appliance.
‧ The appliance must be protected by a residual current protection device
with a maximum rated residual current of 30 mA. Please contact an
electrician if there are any questions or problems.
‧ In the event of leakage or when the residual current protection device is
triggered, immediately disconnect all devices in the aquarium from the
power supply.
‧ If they are not being used, always disconnect all devices in the aquar-
ium from the power supply before you install/remove any parts and
before all cleaning and maintenance work.
‧ Heed the operating manuals for the supplied LEDs, especially the
chapters on safety, commissioning, operation and maintenance.
‧ Protect the mains socket and mains plug against moisture. It is recom-
mended to form a drip loop with the mains cable to prevent any water
running along the cable to the mains socket.
‧ The electrical data of the LED light must match the data of the power
mains. This data is found on the type plate, the packaging and in these
instructions.
‧ The distance from the underside of the light to the highest water mark
must be a minimum of 15 mm.
4.
Preparation
Unpacking
1. Carefully remove all components from the packaging and make sure that nothing is missing or
damaged.
2. Remove the protective film from the furniture.
13