Palazzetti ECOMONOBLOCCHI Instrucciones De Uso página 45

9 COMMISSIONING
AND USING THE
ECOMONOBLOCCO
9.1 DESCRIPTION OF THE PRODUCT
the model" described for the Ecomonoblocco model in
question in the enclosed "Product booklet".
9.2 LIGHTING THE STOVE FOR THE FIRST TIME
It is recommended to do all manual operations using the
glove provided.
LIGHT THE FIRE ONLY IN THE PROVIDED FIREWOOD
HOLDER.
or early season) must be made with reduced loads (~ 2
at low power. Proceed with these rhythms of charge for at
least the next three days, before you can use the product
to its full capacity. This will allow the evaporation of any
or smoke may be generated, caused by evaporation or
drying of certain materials used. This phenomenon will
gradually disappear.
The room should be well ventilated when starting the
Place rolled up balls of paper in the hearth, cover the
Open the comburent air grid completely
).
approximately half the recommended quantity. As soon
Never use alcohol, petrol, kerosene or other liquid fuels
as they can seriously damage the hearth's walls.
materials must be placed at a distance of at least 170
cm from the radiation surface (glass sides of the hearth).
cod. 004771651 MBL - 10/2015 - Palazzetti - PN - Italy
USE AND MAINTENANCE
9.3 CONTROLLING COMBUSTION
PRIMARY COMBUSTION occurs by the intake of air
rapid combustion;
will be slower.
is advisable to completely the primary air to the grate.
based on heating needs or how long you want the load
of wood to last.
SECONDARY COMBUSTION, available on many
Ecomonoblocco models, is obtained by placing pre-
box, the oxygen in the air ignites the unburned gases,
especially the carbon monoxide, which formed during
primary combustion, converting it to carbon dioxide. The
where the secondary air inlet holes are located.
Secondary combustion, where available, is pre-calibrated
hot.
The fireplace is not suitable for continuous flame
operation.
enclosed "product booklet".
Moving the knob towards the - symbol, combustion
- 9.1 -
45