Setting The Welding Current And Welding - Fronius RC Pedal TIG/TMC Manual De Instrucciones

Setting the weld-
ing current and
welding
Operating the equipment incorrectly can cause serious injury and damage.
► Do not use the functions described until you have thoroughly read and understood the
IMPORTANT! When the remote control is connected or the Bluetooth connection is estab-
lished, the welding current set on the power source is only available when the pedal is fully
depressed.
NOTE!
Parameters which can be adjusted on the remote control cannot be altered on the
power source.
1
2
If the remote control's pedal is released, the welding process comes to an end in a con-
trolled manner (gas post-flow, end of welding).
WARNING!
Operating Instructions of the remote control, the power source and all other system
components.
Set the welding current on the power source
Actuate the pedal
The ignition process is initiated (value change 5%).
27