Fm/Aux Settings - Scansonic R4S Manual De Instrucciones

NOW PLAYING INFORMATION
While the stream is playing, the screen shows its frequency, or if RDS information is available, station
name and any further RDS information such as programme name, track title and contact details. If no
information is available, just the frequency is shown. Stereo broadcasts are indicated with an icon at
the top of the screen. To view further information about the broadcast, press Info.
Each time you press Info, another set of information is displayed, cycling through RDS text, further
RDS text (station/programme type), frequency and today's date.

FM/AUX SETTINGS

SCAN SETTINGS
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss)
from weak stations.
To change the scan settings to stop only at stations with good signal strength, select Menu > Scan
setting > Strong stations only? > Yes.
AUDIO SETTINGS
By default, all stereo stations are reproduced in stereo. For weak
stations, this may result in a poor signal-to-noise ratio (hiss). To play
weak stations in mono, select Menu > Audio setting > FM weak
reception: Listen in mono only > Yes.
AUX IN MODE
Aux in mode plays audio from an external source such as an MP3 player.
To play audio with Aux in mode
01 Turn the volume low on both Scansonic R4S and, if adjustable, the audio source device.
02 Connect the external audio source to the Aux In 3.5 mm stereo socket.
03 Either press Mode until the display shows AUX in or select Menu > Main menu > AUX in.
04 Adjust the volume of Scansonic R4S (and, if necessary, the audio source device) as required.
18