Cleaning And Maintenance; Vacation Time; Troubleshooting - Domo DO985RKC Manual De Instrucciones

CLEANING AND MAINTENANCE

CLEANING
Do not use abrasive cleaning agents or solvents.
1. Set the temperature control knob to the "0" position and disconnect the mains plug from the mains
socket.
2. Take out the food and store in a cool location.
3. Clean the appliance with a soft cloth, warm water and detergent.
4. Wipe the door seal with clear water only and then wipe dry thoroughly.
5. After cleaning reconnect and adjust the temperature control knob as desired.
6. Put the food back into the appliance.
DEFROSTING THE FRIDGE
The refrigerator defrosts fully automatically. While the cooling is
running, beads of condensation or hoarfrost form at the back of
the refrigerator. This is normal. It is not necessary to wipe off the
condensation or frost. The rear panel defrosts automatically. The
condensation runs into the condensation channel and is conveyed
to the cooling from where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so
that the condensation can run out.

VACATION TIME

For short vacation periods, leave the control knobs at their usual settings. During longer absences;
1. Remove all foods.
2. Disconnect from electrical outlet.
3. Clean the refrigerator thoroughly, including defrost pan.
4. Leave door open to avoid possible formations of condensate, mold or odors.
POWER FAILURE
· Most power failures are corrected within an hour or two and will not affect your refrigerator
temperatures. However, you should minimize the number of door openings while the power is off.
· During power failures of longer duration, take steps to protect your food by blacking dry ice on top of
packages.
TROUBLE SHOOTING
Problem
The appliance doesn't
work.
28
DO985RKC
Possible causes
· The temperature control is set
to '0'.
· The plug is not fully in the wall
outlet.
· The fuse is blown.
· The wall socket is faulty.
Solution
· Set the temperature control to
a number above '0' to start the
appliance.
· Put the plug in the mains.
· Check the fuses.
· Contact an electrician.