Publicidad
Idiomas disponibles
Idiomas disponibles
GB
%
&
Receiver with 4-channel terminal block and code self-instruction. Equipped with relay outputs through 4
N.O./N.C. unpolirised relay contacts. It can so manage 4 different uses (ex: automatic gear, swing gear,
alarm and garden lights).
It is also equipped with non volatile memory which allows to memorise up to 400 different radiocontrols.
!#
* "
Reception frequency
Supplì
24Vdc Idle consumption
Sensitività
Relay contacts Max current
Relay contacts Mx voltage
Operating temperature
#"
" ()
)
*
#
0 ()
when power is given, the receiver makes an internal check and leds LR1, LR2 will flash 2 times slowly and 2
times quickly, to indicate that everything is ready for following steps.
If you give power to the receiver and press for 10 seconds button P, you can cancel the whole memory. As
soon as you approach to the end of the 10 seconds, leds will flash more quickly to indicate that an important
and delicate operation is completing .
At the end of this phase, LR1, LR2, LR3, LR4 will flash in order for 1 minute, indicating that necessary time
for complete reset is passing by.
#"
"
("
with button P you can choose the output you need to memorize, or you can enter automatically in Out 1.
Now led LR (the one you have selected) will flash slowly for 10 seconds, indicating that self-instruction step
is beginning. Now if you press the transmitter, it self-instructs the code and channel which has been
transmitted with.
If instructions have been correctly followed leds LR1, LR2, LR3 and LR4 will light on for 2 seconds.
After the first storage, leds will be flashing for other 6 seconds, otherwise you will exit from programming
phese.
If during the programming, you insert the same code, leds LR1, LR2, LR3 and LR4 will flash quickly,
indicating that it has already been memorized. During self-instruction, you can memorize up to 400 codes for
each exit.
For example: First user can memorize the 1
nd
rd
th
the 2
, 3
or 4
channel of its transmitter on the same exit Out1 of the the same receiver.
("
#+
If you press botton P and immediately after botton S, you enter in the cancellation procedure and leds LR1
LR2 will flash twice and quickly for 10 seconds.
At this moment, if you press the transmitter, you can cancel the code from the memory.
If cancellation has been correctly carried out, leds LR1, LR2, LR3 and LR4 will light on for 2 seconds.
As soon as code has been cancelled, the receiver automatically exits from this step. If you want to cancel
another code you have to repeat the procedure from the beginning.
Important: with the cancellation, you exclude from memory of the receiver the code of that transmitter, with
all its channels (if memorized), irrespective of the channel which effected the cancellation.
For example, if cancellation has been done with channel 1, automatically also channels 2 – 3 and 4 will be
cancelled.
433,920
24
12
-108
1
24
-10/+70
#+
(#
*% #
&
(#
st
transmitter channel on exit Out1, a second user can memorize
/
Mhz
Vac/Vdc
mA
Dbm
A
Vac
° C
Publicidad
