Publicidad
Idiomas disponibles
Idiomas disponibles
(& )&
) (+
Button S give the possibility to select the output you would like to program (Out1, Out2), by highlighting the
chosen output through signalling led LR1,LR2, LR3, LR4.
Each time you press button S, you select a different output, passing from LR1 to LR4, with a cyclical
sequence LR1-LR2-LR3-LR4-nothing-LR1...
Once you've chosen the output to be programmed, button P allows you to formulate the exit as monostable (
1 flash on led LR); bistable (2 flash on led LR); timerized (3 flash on led LR) and ON-OFF (4 flash on led LR).
By pressing button P you can change the numbers of flashes of an exit and therefore its programming.
In this way exits can be programmed, in different ways one from the others.
For Example: Out1 has been programmed in impulsive way and Out 2 step-by-step.
Important: In case no exit has been chosen through botton S, button P will automatically program the first
exit.
("
*%
(
It is possible to carry out the self-memorisation by radio, following a predetermined order. With this order it is
possible to memorise a new remote control having one already memorised.
Stage 1 – Press for at least 15 consecutive seconds with an already memorized remote control
Stage 2 – Press one time with the remote control that has to be memorised (within a maximum time of
further 10 sec.)
If the procedure is correctly carried out, the memorisation is done.
The control unit exits automatically from the programming phase:
-
as soon as the maximum time of 10 seconds (during stage 2) is off, without any new impulse
-
when a new remote control is memorised.
If you wish to memorise more than one remote control, it is necessary to repeat every time the
predetermined order.
Microcontroller can recognize an already memorized transmitter and it knows on which output it has been
memorized and which kind of programming (monostable, bistable, temerized, ON-OFF) it has; in this way the
new transmitter will be placed in the same output, with the same programming.
For example: on transmitter A, channel 2 has been memorized on exit Out 2 as step-by-step, on the new
transmitter you can memorize, via radio, the same output of transmitter A, Out 2 and with the same selection
step-by-step, on channel 1,2,3 or 4:
()
(#
(
-
-* (& )&
By programming the exit as bistable, at each impulse given by the transmitter the output changes its
condition. If there's no power and relé is active, this will be deactivate.
' " (& )&
Time of timer has been fixed on 30 seconds; there's the possibility to extend it to 180 seconds (joining
platform A)
(# (%% (& )&
If output is formulated as ON-OFF, you need to memorize contemporary transmitters channels 1 and 2, and
channels 3 and 4 on the requested outputs. In this way, if you press channel 1 or 3 of the transmitter, it will
always work as ON, while pressing channel 2 or 4, it will always work as OFF.
*
(# .& )
Select power at 12 Vcc/Vac.
#
##
In order to improve transmitter's reception and range, we suggest the installation of a special antenna. To
better exploit its performance, antenna should be fixed on the highest point, on metal supports. For the
connection cable between antenna and receiver, we suggest to use 50 ohm impedance cable (ex. RG58).
This cable should not be longer than 10 m.
#+
'
(# ,
" (
#"
" ()
1
#+
Publicidad
