Getting Started - J5create JUD200 Manual Del Usuario

NEWPORT STATION

GETTING STARTED

Notes for Before Installation
Install the driver completely before inserting the USB cable into your computer

Run the setup program as an administrator to avoid errors in installation

Connect the VGA of Display device to the VGA port of Newport Station first

before connecting the USB cable to the computer
Un-install the previous driver first before installing the latest driver

Enjoy the Newport Station
1. Start Device Driver Installation (please refer to your PC system OS installation in next
section)
*Note: install driver completely before following steps.
2. Plug the Power Adapter to Port 1
3. Connect USB 2.0 Cable Micro-B connector to Port2, Type-A connector to host laptop
4. Connect VGA Cable of Display device to Port 4
5. Connect Ethernet Cable to Port 7
6. Connect Audio Cable(audio out, audio in)to Port 8 & 9
7. Lay your laptop on the top of the j5 Newport Station
8. Push the "j5" power button
9. USB 2.0 HUB port 3,5,6 are now ready to use
7
USER MANUAL