Operation Of The Radio - Monacor PA-1200RDSU Instrucciones Instalación Y Funcionamiento

Button Function
To start, pause and continue the
II

replay
Press briefly to stop the replay .
/
 Keep pressed until the display goes
dark to switch off .
Press briefly to go to the next / pre-
vious title .
I TRACK I
 
Keep pressed for fast forward / re-
verse (without any sound) .
FOLDER To go to the next / previous folder .
 
INTRO – replay of the first 10 s of the
INT
REPEAT – repeat of replay of the
When the button is pressed again,
RPT
the indication REPEAT starts flashing
and all titles in the folder will be
repeated* .
RANDOM – replay of titles in random
RDM
* To exit a function, press the button once again or
press one of the three buttons .
5.1.1 Automatic or manual start of replay
The audio player mode is selected . The module or
the unit into which the module has been installed
is switched off . The next time it is switched on
again, the replay will either start automatically or
manually by means of the button
To switch between automatic and manual
start, keep the button
is replayed until the display indicates MANUAL
or AUTO .
10
PA-1200RDSU
titles*
current title
order*
II .

II pressed while a title

1/ 2/INT 3/RPT 4/RDM 5/ FOLDER /6
TRACK
MODE BAND TUNE

5.2 Operation of the radio

The radio is able to receive FM and AM stations .
Multiple stations can be assigned to the six sta-
tion buttons (1/ . . . / 6) . Therefore, it is possible to
store 3 × 6 FM stations (F 1, F 2, F 3) and 6 AM
stations (MW) .
5.2.1 Station tuning and storage
1) If AF is indicated at the bottom of the dis-
play, press the button AF to switch off this
indication .
2) Use the button BAND to select the desired
bandwidth (F 1, F 2, F 3, MW) .
3) Use the automatic scanning to find a station
or tune the station manually:
To start the automatic scanning, briefly press
the button TUNE

The scanning will stop at the next station . Re-
start the scanning repeatedly until the desired
station is received .
For manual tuning, keep the button TUNE
I or I pressed until the desired reception
 
frequency is roughly reached . Then press the
button to increase or reduce the frequency step
by step (in the FM band by 0 .05 MHz; in the
AM band by 9 kHz) . After manual tuning, the
radio will return to automatic scanning after a
few seconds . To prevent this, press the button
or I again before the radio switches over .
I
 
4) When the desired station has been found, keep
the desired station button (1/ . . . / 6) pressed
until "F" or "MW" on the left of the display
changes to "M" (memory) .
5.2.2 Calling up stations
which have been stored
1) Use the button BAND to select the bandwidth
where the desired station has been stored .
2) Press the corresponding button (1/ ... /6) of
the station .
For stereo broadcasts, the symbol
the top left of the display .
PTY AF
0 10
LEVEL
I (forward) or I (reverse) .

appears on