Operation And Cleaning; Control Descriptions; Pan And Tool Fitting - Fimar IP10F Manual De Uso

Control descriptions

1) Start button "I"
Press this button to start tool rotation.The start button will only be
enabled when the lid is closed and the pan is in place.
2) Stop button "0"
Press this button to stop tool rotation.
3) Timer (only mod.IP60F-80F)
It allows the working time to be set.
Timed operation position (0 to 15 minutes): turn the knob
clockwise on the graduated scale.
Continuous operation position: turn the knob counter-clockwise to
the "manual" position.
4) Tool speed adjustment lever
It allows the tool rotation speed to be adjusted according to the
operation to carry out.
Three different speeds:
1 – 95rpm (mod.IP10F-20F-30F-40F); 70rpm (mod.IP60F-80F)
2 – 175rpm (mod.IP10F-20F-30F-40F); 210rpm (mod.IP60F-80F)
3 – 320rpm (mod.IP10F-20F-30F-40F); 360rpm (mod.IP60F-80F)
Adjust the tool rotation speed only when the machine is off.
5) Pan lifting handwheel
It allows to lift (clockwise rotation) or to lower the pan (counter-
clockwise rotation).

Pan and tool fitting

Pan:
•
Lower the pan bracket completely by rotating the lateral
handwheel counter-clockwise.
•
Insert the lateral handles of the pan on the pivots of the
pan bracket and lock the handles by pulling.
•
Lift the pan, so-fixed, by rotating the handwheel clockwise.
Tool:
•
Lower the pan completely by rotating the lateral handwheel
counter-clockwise.
•
Open the cover and insert the tool on the drive shaft.Then
lock it by rotating it counter-clockwise.
•
Close the cover and lift the pan by rotating the lateral
handwheel clockwise.
Translation of the original instructions
OPERATION AND
CLEANING
3