REMIS REMIfront IV-M Instrucciones De Montaje página 16

C10
US/GB
C11
C12
C13
C14
16/60
C10:
Now remove any redundant pieces of textile.
C11:
Check the position of the cables inside the nut again and
press the A-pillar facing against the car's A-pillar.
C12:
Carefully press against the A-pillar facing at the spots mar-
ked in the illustration, until you can hear the sound of the
clips snapping in.
C13:
Press the door sealing rubber in again.
Repeat this procedure on the other side.
C14:
Screw the two long tubes (860mm) through the holes in
the A-pillar facing's plissées onto the tube holders.