Parking Brake Inhibit
• When the "BRAKE" cable is connected to
the brake switch, the display on the TFT
monitor will display video only when the
vehicle is applied.
• Parking brake function is overridden when
the video source is set to REVERSE.
• When the parking brake inhibit is active,
the front monitor displays "Warning!!! It
is illegal to view video while driving or
operating a motor vehicle. Set parking
brake to view video.", preventing the driver
from watching content while driving. Rear
video screens are not affected.
Mute
Press [ VOL/
/MUTE ] knob to mute the
volume from the unit. Press again to restore
the volume.
Adjusting the volume or using any of the
audio setup features cancels the mute
function.
Power On / Off
Press the [ VOL/
/MUTE ] knob on the unit
to turn the unit on. The buttons on the front of
the unit light up for a moment and the current
mode status appears in the LCD.
Press and hold the [ VOL/
power off the unit.
Audible Beep Confirmation
An audible beep tone confirms each function
selection. The Beep tone can be disabled
through the Setup menu.
Basic Operations
/MUTE ] knob to
EN-7
Playing Source Selection
Press the [ MENU ] button on the front panel
to change between available playing sources.
The playing mode is displayed on the screen.
1
2
1.
or
: Touch this page button to view
the first or second page of on-screen
buttons
2. Function icons
3. Clock
4. EQ: Touch to access Equalizer level
settings menu.
Volume Adjustment
To increase or decrease the volume level,
turn the [ VOL/
/MUTE ] knob on the front
panel. The volume ranges from "0"to "50".
The LCD or TFT screen displays the volume
level for 3 seconds.
EQ Menu
The Audio Control feature allows you to
easily adjust your audio system to meet the
acoustical characteristics of your vehicle,
which vary depending on the type of vehicle
and its measurements. Proper setting of the
Fader and Balance boosts the effects of the
cabin equalizer.
3
4
1