Agri-Fab 45-03451 Manual Del Usuario página 6

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
8. Assemble the hitch bracket to the front tongue using
two 3/8" x 1" hex bolts (B) and 3/8" nylock nuts (M).
Tighten. See figure 4.
9. Assemble the leg stand bracket to the front tongue using
two 5/16" x 1" hex bolts (C) and 5/16" nylock nuts (L).
Tighten. See figure 4.
LEG STAND
BRACKET
(C) 5/16" x 1"
HEX BOLT
FRONT
TONGUE
(L) 5/16" NYLOCK
NUT
FIGure 4
10. Place the front tongue inside the rear tongue as shown
in figure 5. Fasten the tongues together using a 3/8"
x 4" hex bolt (A) and a 3/8" nylock nut (M). Tighten,
leaving the nut just loose enough that the tongues can
pivot freely. See figure 5.
11. Insert the 3/8" x 4" clevis pin (G) through the tongues
and secure with a 1/8" hairpin cotter (N), as shown in
figure 5.
FRONT
TONGUE
(G) 3/8" x 4"
CLEVIS PIN
FIGure 5
enGlIsH
(B) 3/8" x 1"
HEX BOLT
HITCH
BRACKET
(M) 3/8" NYLOCK
NUT
(N) 1/8" HAIRPIN
COTTER
(M) 3/8"
NYLOCK NUT
(A) 3/8" x 4"
HEX BOLT
6
www.mymowerparts.com
12. Assemble an axle clip (S) and a wheel with the valve
stem facing out onto the axle. Assemble a hub cap (Q)
by pressing or tapping it onto the axle. Repeat on other
end of axle. See figure 6.
WHEEL
(Q) HUB CAP
FIGure 6
13. Turn the assembled tongue, wheel support and wheels
over to the upright position. Place the latch stand bracket
onto the tongue between the latch lock assembly and
the raised tab. Place the poly tray onto the wheel support
and latch stand bracket. Fasten the tray to the wheel
support using eight 5/16" x 3/4" truss head bolts (F) and
5/16" nylock nuts (L). Do not tighten yet. See figure
7.
14. Place the latch stand plate between the latch stand
bracket and the poly tray. See figure 7.
LATCH
STAND
PLATE
FIGure 7
AXLE
(S) AXLE CLIP
(F) 5/16" x 3/4"
TRUSS HEAD
BOLT
(L) 5/16"
NYLOCK NUT
LATCH STAND
BRACKET